Northern Hydraulics products for sale right here. Buy Northen Hydraulics supplies and save money. Click here
Response rate, header height, and row unit height can be conveniently adjusted on-the-go from the cab. Simple buttons are used to raise and lower the unit, and the old levers and mechanical linkages have all been replaced with state-of-the-art electronic controls. Row-Trak Guidance is also available on the new head. With this system, the operator will automatically stay on the row without constant steering adjustments. Simply line-up the stripper with the rows, hit the Row-Trak Guidance switch, and the system will take over, steering the stripper and keeping it on the row.
The increase of one horsepower over the GC160 and GCVl60, to 6.0 horsepower and 6.5 horsepower for the GC190 and GCV190 respectively, was achieved through an increase of displacement from 160 to 187 cc. This also results in a 0.5 lb.ft. torque increase for both engines, with the GC190 delivering 8.9 lb.ft., and the GCVI90 delivering 8.1 lb.ft.To maintain reliability with the higher output, internal components have been strengthened with a stronger piston pin, larger connecting rod, larger rod journal and redesigned oil control ring.
Most pressure washers that you''ll find for rent or sale are gas-powered. This type can deliver higher water pressure than the electric kind, some more than 3,000 psi. But gas-powered washers also require more water: 2 to 3 gpm. These washers are the best choice for bigger jobs like preparing siding for painting (Photo 2), removing "aging" stains from wood decks (Photo 5) and deep-cleaning concrete. You can rent one for about $60 a day, plus the cost of accessories like chemical injectors (Photo 1) or longer spray wands for reaching high places. Gas-powered washers (non-commercial units) cost $300 to $800 depending on the pressure they deliver, their features and the engine and pump quality.
Though light in weight, Airbor magnetic drill has a powerful 1.6-hp air motor and 1,600-lb magnetic holding strength. With its extra rack, stroke length is extended to 10 1/4 in. Annular cutter capacity is up to 2 1/16 in. diam. Geared chuck adapter converts the unit to a standard drill press. The Slugger Air Force pneumatic drill, at 24 lbs, 6 1/4" high, is useful for confined area drilling. The drill''s features include a permanent magnet that turns on or off by air power, a cutter capacity of up to 1 1/16" diameter x 3/4" depth and the ability to use ShortSlugger cutters and frame cutters. These cutters'' geometry allows the operator to drill multi-layered truck frames in a single pass.
© Copyright 2003. www.northern-hydraulics.com. All Rights Reserved